Friday, September 13, 2013

Part 6 - FiberwerX Replacement Bedside Panels

So at the beginning of the build you may have seen our crate of fiberglass fenders come in from FiberwerX. We mounted up the front fenders and we were working on the front suspension at the time. Now it's time to cut up the stock bedside panels for a more appropriate looking fender.
 
 
This is what we're starting with and what we're going to achieve
 
 
First, lets get rid of the stock panel.
There's about a million spot welds holding these panels on so we invested in a spot weld removal drill bit to make life much easier.
(Also drilling a 1/8" pilot hole through the weld helps prevent the bit from skating all over the place as you can see)
 
You'll have to look very careful for all the spot welds, sometimes they're hard to see through the paint.
 
To get at the front we needed to move the box away from the cab and drill out more spot welds

 
On the inner fender we opted out and used the plasma cutter to make short order of the wheel well support
 
Now it's time to remove the panel
 
 
 
The lip that we cut previously now has to be ground down flush

 
Now for a test fit....
 
At the back of the box there's a rear brace that hangs down. We marked a line in what we needed to cut off and out come the plasma again.

 
It's a good idea to spray some sort of rock guard protection on the inside of the fiberglass panels. Reason for this is to help strengthen and protect against rocks and debris from puncturing through. 
 
 
While we're at it, might as well give the inner box panel a shot of rock guard as well
 
Next all the provisions for the Taillights and Fuel Door have to be cut out. All we used was a die grinder with a 3" cut-off wheel.




 
All that's left to be done is to mount up the bedside panel to the truck box using some self-tapping machine tech screws. Make some support brackets for the bottom of the wheel well's and that's pretty much it.
 
Not that difficult to do but takes a bit of time and patience.
That's if you don't mind cutting up your truck to get the look .....
 

 
A glimpse on how the profile of the F150 is looking now

 
We'll post more updates on the Cap-it Facebook page as we make more progress with the build. Make sure to LIKE us to get the latest news and updates with Cap-it.
 
 
 
 
 
 

1 comment:

  1. Unlock unparalleled control over your fleet with the X-Press Converter Tool for sale, now available for sale. Revolutionize your trucking operations by effortlessly streamlining logistics, tracking shipments, and optimizing efficiency. Don't miss the opportunity to enhance your fleet management capabilities with this cutting-edge tool.

    ReplyDelete